Preview

Izmeritel`naya Tekhnika

Advanced search
Open Access Open Access  Restricted Access Subscription Access

Анализ источников погрешностей входного блока модифицированного нулевого микроволнового радиометра

Abstract

A procedure for carrying out calibration is described and the expressions are obtained to estimate the influence on the accuracy of measurement of deviation of characteristics of the elements of the input path of a microwave radiometer based on the nominal values. The limits are determined both for the change of physical temperature of an input unit and the receiver noise temperature, within the range of which the output signal changes do not exceed the radiometer fluctuation sensitivity.

About the Author

А. Филатов
Томский государственный университет систем управления и радиоэлектроники
Russian Federation


References

1. Филатов А. В., Каратаева Н. А., Дмитриев В. Д. Микроволновый нулевой радиометр с комбинированной импульсной модуляцией // Измерительная техника. 2007. № 3. С. 65-69.

2. Филатов А. В. Новый подход к построению радиотехнических СВЧ-устройств пассивной локации на принципе синхронного совмещения двух видов импульсной модуляции // Доклады ТУСУР. 2011. №2(24). Ч. 3. С. 20-26.

3. Филатов А. В., Убайчин А. В., Параев Д. Е. Применение концепции нулевого метода измерений в микроволновых радиометрах // Известия вузов. Радиоэлектроника. 2011. № 4. С. 41-55.

4. Brown S., Desai S., Lu W. and Tanner A. On the Long-Term Stability of Microwave Radiometers Using Noise Diodes for Calibration // IEEE Trans. Geosci. Remote Sensing. 2007. V. 45. N. 7. P. 1908-1920.

5. Xu W. T., Yand C. T. Microwave Radiometer Calibration and Its Error Analysis // Digest CPEM '88. Tsukuba, Ibaraki, (Jap.), 1988. P. 390-391.

6. Han Y., Westwater E. R. Analysis and Improvement of Tipping Calibration for Ground-Based Microwave Radiometers // IEEE Trans. Geosci. Remote Sensing. 2000. V. 38. N. 3. P. 1260-1276.


Review

For citations:


  . Izmeritel`naya Tekhnika. 2016;(3):40-43. (In Russ.)

Views: 61


ISSN 0368-1025 (Print)
ISSN 2949-5237 (Online)