Preview

Izmeritel`naya Tekhnika

Advanced search

Индивидуальная градуировка термометров сопротивления для измерения разности температур

Abstract

Four methods for calibration of platinum resistance thermometers used in the heat control devices are analyzed. The criteria for this analysis is minimizing the measurement error and reducing the calibration cost. It is shown that calibration technique can be based on the investigation of individual coefficients typical for particular lot of thermometers. It is especially important if the thermometers are made with use of platinum film sensor.

About the Author

Н. Моисеева
Всероссийский научно-исследовательский институт метрологии им. Д. И. Менделеева, С.-Петербург
Russian Federation


References

1. ГОСТ Р 8.625-2006. ГСИ. Термометры сопротивления из платины, меди и никеля. Общие технические требования и методы испытаний.

2. IEC 60751:2008. Industrial platinum resistance thermometers and platinum temperature sensors.

3. ГОСТ Р 8.624-2006. ГСИ. Термометры сопротивления из платины, меди и никеля. Методика поверки.

4. Moiseeva N. P. Investigation of W(T) functions for low-α PRTs in the sub-ranges above 0 °C //Temperature: its measur. and control in sci. and industry: Proc. AIP conf. Melville, N. Y., 2003. V. 7. P. 333 - 338.

5. Моисеева Н. П. Исследование интерполяционных зависимостей для ТСП в узких диапазонах температур //Измерительная техника. 2004. № 11. С. 39 - 43;

6. Moiseeva N. P. Investigation of the interpolation relations for a platinum resistance thermometer over narrow temperature ranges //Measurement Techniques. 2004. V. 47. N 11. P. 1090 - 1095.

7. Моисеева Н. П. Неопределенность значения температуры, измеренной платиновым термометром сопротивления //Приборы. 2002. № 12. С. 30 - 34.

8. ГОСТ Р ЕН 1434-5-2006. Теплосчетчики. Ч. 5. Первичная поверка.

9. Crovini A. е. а. Precision calibration of Industrial Platinum Resistance Thermometers //Temperature: its measur. and control in sci. and industry: Proc. conf. AIP. 1992. V. 6. P. 1077 - 1082.


Review

For citations:


  . Izmeritel`naya Tekhnika. 2010;(9):50-53.

Views: 122


Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.


ISSN 0368-1025 (Print)
ISSN 2949-5237 (Online)